Rear Chamber Installation Manual (connections)

Congratulations on acquiring our rear camera for Android screens for BMW! This manual will guide you through the installation process (connections) step by step.

Your rear camera comes with a 2 -year warranty. If you experience any problem or need additional assistance, please contact our technical support team through WhatsApp or Email.

Remember that you can request assistance during the installation process asking for an appointment  with our technical support team through WhatsApp or Email.

1. Connection

✏️ [important] If your BMW has an automatic gear change, at the rear we will perform the joints, but we will not connect it to positive or dough, we will leave them isolated with insulating tape. In case of not working, then if we will connect it to positive and mass.

Rear end (pilot): We make the RCA connection (yellow male/female connector) and then we proceed to join the red cables and connect them to the positive back light cable. Then we join the negative cables and connect them to mass (car sheet).

Front end (screen): We connect the red wire to the reversal trigger of the screen and make the RCA connection to the video camera input.

Attention! All connections must be isolated by insulating adhesive tape.

2. Problems and solutions

- The image is seen the other way around or in mirror mode
In camera settings deactivate the mirror/inverted image option.

- Sometimes the image is only shown for a few seconds or is seen with stripes (blurred/interference)
You must install a filter [To buy it click here] between the connections of the camera and the pilot/mass.